IC

24C08 8K Bit standard 2 wire bus interface serial DIP 8 pin IC pack of 2pcs

Specification

1. Low Voltage and Standard-Voltage Operation
2. 2-wire Serial Interface
3. Operating voltage : 2.7V to 5.5V
4. Clock frequency :  40KHz
5. Active current typical : 200µA
6. 100kHz and 400kHz Compatibility
7. 1024 x 8 bits for each

LM3914 Logarithmic LED dot or bar display driver 18 pins IC pack of 50pcs

Specification

1. Analog controlled LED Driver IC
2. Number of controllable LEDs : 10
3. Operating voltage :  3V to 18V
4. Input analog voltage range : 1.2V to 12V
5. LED sink current :  2mA to 30mA (programmable)
6. Both Dot and Bar display mode available

VG24A KA3525A SMPS power supply controller DIP 16 pin IC

Specifications:-

• SMPS switching controller IC
• AC to DC converter
• Input Voltage: 40V
• Output Voltage: 5V
• Output Current: 500mA

UPC1230H2 25W Audio power amplifier bipolar analog 12 pins IC pack of 10pcs

Specification

1. Supply voltage range: 9.5V to 18V
2. Operating voltage: 16V
3. Circuit current: 4.5A
4. Power dissipation: 20W
5. Load impedance: 3.2Ω to 16Ω

CD4017 Decade counter noise immunity DIP 16 pin IC pack of 2pcs

Specifications:-

1. Type : Decade counter IC
2. Supply voltage range : 5V to 15V
3. Power dissipation : 700mW
4. Supports 10 decoded outputs
5. High noise immunity : 0.45
6. Low power : 10 µW
7. Maximum clock frequency :  5.5Mhz

LM311 Differential comparator op-amp DIP 8 pins IC pack of 10pcs

Specification

1. Wide power supply Range
   1. Singe supply :  5V to 30V
   2. Dual supply : ±2.5V to ±15V
2. Maximum current : 7.5mA
3. Single supply for two op-amps enables reliable operation
4. Capable of driving load up to 50V and 50 mA

TDA7297 Dual channel 15W + 15W stereo audio power amplifier 15 pins IC pack of 10pcs

Specifications

1. Dual-channel amplifier IC
2. Stereo output: 15W + 15W
3. Operating voltage: 6V to 18V
4. Peak output current:  2A
5. Maximum quiescent current: 65mA
6. Closed-loop voltage gain:  33dB

TA8263BH 43W 4 Channel audio power amplifier bipolar linear 25 pins IC pack of 50pcs

Specification

1. Supply voltage range : 9V to 18V
2. Operating voltage : 15V
3. Power dissipation : 43W
4. High power output
5. Built-in diagnosis circuit
6. Low distortion ratio
7. Low noise

LM358 Dual operational amplifier 8 pins IC pack of 10pcs

Specifications

1. Dual operational amplifier
2. Number of amplifiers: 2
3. Number of pins: 8
4. Wide power supply Range
5. Singe supply: 3V to 32V
6. Dual supply: 1.5V to 16V
7. Low Supply current – 700uA
8. Short circuit protection outputs

LM3915 Logarithmic LED dot or bar display driver 18 pins IC pack of 10pcs

Specification

1. Analog controlled LED driver IC with logarithmic output
2. Operating Voltage :  3V to 25V
3. Reference Voltage :  1.2V to 12V
4. Power dissipation : 1365 mW
5. Number of pin : 18
6. Number of controllable LED's : 10
7. Drives LEDs, LCDs, or Vacuum Fluorescents

LM393 Low offset voltage dual comparator operational amplifier 8 pins IC pack of 10pcs

Specification

1. Dual comparator
2. Wide power supply range
   1.     Singe supply – 2V to 36V
   2.     Dual supply – ±1V to ±18V
3. A drain current of only 0.4mA
4. Input offset voltage: ±5mV maximum
5. Power dissipation: 660mW
6. Can drive most of the TTL and MOS loads

CD4052 4 Channel multiplexer and demultiplexer DIP 16 pin IC pack of 2pcs

Specification

1. Nominal voltage : 5V to 15V
2. Maximum operating voltage : 20V
3. Propagation delay : 400ns at 5V
4. Supports both analog and a digital voltage
5. 4:1 Multiplexer IC
6. 1:4 Demultiplexer IC