SENSORS & MODULES
Showing 1–12 of 868 results
-
13mm x 10mm Strong Silver Cylindrical Shape Neodymium Magnet
Rs. 109.00Specification:-
- Material: Neodymium (NdFeB)
- Shape: Cylindrical
- Dimension: 13mm x 10mm
- Magnetization: Axial
- Operating Temperature: -40°C to +80°C
- Coating: Ni+Cu+Ni (Nickel Coated)
-
5A 12V Overcurrent Protection AC Current Detection Sensor Module
Rs. 349.00Specification :-
- Output mode: Switch signal output
- Operating voltage: DC12V
- Operating current: <20MA
- The current detection range: AC 0.3A-5A
- Operating frequency range: 20Hz ~ 400Hz
-
1S 6AMP LFP BMS Hardware
Rs. 29.00Specification:-
- Charging Voltage: DC 3.6V CC/CV
- Max continuous charging current: 6A
- Over charge detection voltage: 3.65±0.05V
- Over discharge detection voltage: 3.0±0.05V
- Over current detection current: 0.18±0.015V
- Operating Temperature: -45°C to +65°C
- Storage Temperature: -45°C to +85°C
- Model No.(7fcd)
-
8S 60A BMS LFP Hardware Waterproof
Rs. 1439.00Specification:-
- Battery Configuration: 8S for LiFePO4 (LFP) batteries
- Continuous Discharge Current: 60A
- Over-Voltage Protection: 3.8V
- Balancing Current: 50mA
- Charge Voltage: 29.2V
- Model no. (11d6)
-
5.4mm x 0.7mm (10×2.5 mm) Strong Silver Disc Shape Neodymium Magnet Pack of 2
Rs. 39.00Specification:-
- Material: Neodymium (NdFeB)
- Shape: Disc
- Dimension: 5.4mm x 0.7mm (10×2.5 mm)
- Magnetization: Axial
- Operating Temperature: -40°C to +80°C
- Coating: Ni+Cu+Ni (Nickel Coated)
-
47μH 3A Ferrite Magnetic Inductor Coil 0.6mm Wire dia (12x6mm)
Rs. 39.00Specification:-
- Inductance: 47μH
- Core Material: Ferrite
- Outer Diameter: 12mm
- Height: 6mm
- Current Rating: 3A
- Wire Diameter: 0.6 mm
- Shape: Toroidal
-
Smart BMS LiFePO4 24S 72V 50A Common Port with Balance
Rs. 6859.00Specification:-
- Battery Configuration: Smart BMS LiFePO4 24S 72V 50A
- Continuous Discharge Current: 50A
- Over-Voltage Protection: 3.8V
- Charge Current: 25A
- Charge Voltage: 87.6V
- Model no. (46cb)
-
ENC28J60 Ethernet Module 12-Pin
Rs. 399.00Specification:-
- 25MHz Crystal
- 5 V power supply pin
- Driver IC : ENC28J60-I/SO
- Ethernet Port: HanRun HR911105A
- Compatible For Arduino, SPI, AVR, PIC, LPC, STM32
Pin Configuration:
- 5V: 5V power supply
- GND: Ground
- LNT: Interrupt pin
- CLK: Clock output from ethernet controller
- SO: SPI Output
- WOL: Wake-on-LAN (optional)
- SCK: SPI Clock
- ST: SPI Input
- RST: Reset pin
- CS: Chip Select
- Q3: that this is the RX 3.3V supply
-
12S 2A Lithium Battery Balance Board
Rs. 999.00Specification:-
- Software active equalization
- Number of battery pack strings: 12S
- Balance current ≤2A
- Balance mode - Active equilibrium
- working temperature: -20°C~60°C
- Model no. (5425)
-
Smart BMS LiFePO4 19S 60V 60A Common Port with Balance
Rs. 5419.00Specification:-
- Battery Configuration: Smart BMS LiFePO4 19S 60V 60A
- Continuous Discharge Current: 60A
- Over-Voltage Protection: 3.8V
- Charge Current: 35A
- Charge Voltage: 69.35V
- Model no. (219e)
-
16S 60A BMS LFP Hardware Waterproof
Rs. 2269.00Specification:-
- Battery Configuration: 16S for LiFePO4 (LFP) batteries
- Continuous Discharge Current: 60A
- Over-Voltage Protection: 3.8V
- Balancing Current: 50mA
- Charge Voltage: 58.4V
- Model no. (10cb)
-
Smart BMS LiFePO4 23S 72V 50A Common Port with Balance
Rs. 5609.00Specification:-
- Battery Configuration: Smart BMS LiFePO4 23S 72V 50A
- Continuous Discharge Current: 50A
- Over-Voltage Protection: 3.8V
- Charge Current: 25A
- Charge Voltage: 83.95V
- Model no. (46ca)